Thursday, September 22, 2011

Took computer apart to change dvd driver and now it wont start?

swopped the dvd re-writer from downstairs computer to upstairs computer and now came to switch it on and it doesnt turn on. when the power is plugged in there is a lil yellow light on the mother board so thats workin fine? any idea or how much it will cost to fix?Took computer apart to change dvd driver and now it wont start?A shot in the dark here.

Do you have a floppy drive?

Did you disconnect the power cable while working with the DVD drive?

If so, check to ensure that the power cable to the floppy drive is connected properly. Should you be 1 pin off this will cause the power cable to go to ground and the computer will not boot, even though it has power.Took computer apart to change dvd driver and now it wont start?Check to see if all your cables are plugged in to every component especially the motherboard. Make sure you plugged the computer back in too.



Dont just look at them and say %26quot;Yep they are plugged in%26quot; push all of them in to make sure!



Let me know.Took computer apart to change dvd driver and now it wont start?You may have pulled one of the power leads from the Heatsink power unit to the motherboard.

Check all the cables are plugged into the components and try again.

No comments:

Post a Comment